Wavlink wifi repeater is often used by people to get a strong and reliable internet connection with no WiFi dead zone. WiFi dead zones are a common problem faced by people in home or office networking systems. This is where the wavlink wifi repeater comes into play. Setting up a repeater is not a hard task if you know the process. Here on this page we specify Wavlink WiFi Repeater Instructions clearly that will help the new users to add the wifi repeater device in their existing network. In addition to the setup process on this page further you will also find troubleshooting tips.
Wavlink WiFi Repeater Setup Instructions
Wavlink WiFi Repeater instructions for setup are as follows. Go with these instructions to configure your wavlink repeater. But before that make sure you have everything you need including repeater, power outlet, ethernet cable etc. let’s dig into the process:
Find A Location
Begin with finding the location for the repeater device from where the repeater can easily receive signals and transmit too. A location with minimal network interfacing devices and closer to the area where the network is not working properly. Also next to the router.
Power Up
Connect the power adapter of the repeater. Switch on the power supply and your device will be ready after 5 minutes when LED’s get stable.
Choose Client Device
Now, decide which device you are about to use to follow further wavlink wifi repeater instructions. You can use mobile or computer or laptop or tablet device having an updated version of browser.
Connect To Network
Connect the device you are using to the repeater network to proceed with the repeater setup. Either opt for wired connection or wireless connection.
Launch Browser
Any browser you have you can use just make sure the version is the latest one to avoid trouble.
Access Setup Page
Move to the next step and access the setup page by using the default IP along with default admin details.
Configure Repeater
Begin the configuration of the repeater by using the router’s wireless network details. The setup wizard will give you complete instructions for wavlink wifi repeater setup.
Security Changes
Make changes in the security settings of the repeater to keep your network secure. If the default information is not replaced by you then anyone can access the setup page. Change the admin details and wireless details too.
Finish Setup
End setup by submitting the changes you made and then use your client device to test the network by again connecting to the repeater’s network.
Wavlink Wifi Repeater Troubleshooting Instructions
Resolve all the common issues including slow internet speed, no signals, weak signals, unable to access setup page and more by following these instructions as mentioned:
- The first step to resolve the issue is to check the hardware connections of the repeater device. If you find any damage then replace it to restore the network. In case no damage is found then you have to step forward and check for the host network connection. If there is no internet in the host device then call your ISP.
- Secondly you need to try relocating the repeater device a bit closer to the router device. This might help. Further eliminate the network interfacing devices placed closer to the repeater.
- The third step is rebooting. Rebooting resolves several issues that arise due to temporary causes. Rebooting may take only 5 minutes. In this step you need to cut off the power supply first and then wait for sometime (a minute or two). Again supply the power to repeater and check if the issue is resolved.
- The fourth step is checking the firmware update. Firmware is very important for a repeater device to perform well. From time to time manufacturers release firmware updates to enhance the features of the device and fix bugs. Check for the update by visiting the setup wizard using admin login. If update is available then install it by following the wavlink wifi repeater instructions displaying on the screen.
- Lastly you can reset the device back to factory settings and again configure it to resolve the issue. This will definitely help you to restore the network. If not then you should connect technical experts for help. For resetting the device you need to use the reset button given on its back. Press the button till the LED lights start blinking faster.
Conclusion
Hope the above mentioned Wavlink wifi repeater instructions are clear to you. These instructions will help you to configure the repeater device. Furthermore if you encounter any trouble with the repeater network such as slow internet speed, no signals, weak signals then you can easily resolve it. On the above page you will find a detailed troubleshoot guide that helps the users in resolving issues.
Comments