Electric Actuated Gate valve manufacturer in Germany:
Are you looking for the best electric actuated gate valve manufacturer in Germany? Valvesonly Europe is one of the leading Electric Actuated Gate Valve Manufacturer in Germany . An Electric Actuated Gate valve which is used to completely shut off the fluid flow or completely open the same. An electric actuated gate valve is operated automatically. They require a little space along the pipeline. These valves are less complex to construct than any other types of larger valves. It consists of three components which is the body, bonnet, actuator, and trim. They are mostly used in refineries, petrochemical and process plants. They are suitable for steam, oil, water, and gas.
Advantages of Electric Actuated Gate Valve:
· It is suitable for both above ground and underground installation.
· The closuring feature of this valve is exceptionally good.
· These valves can be used in both ways in circuit.
· Pressure loss is minimum
Size: DN15 to DN700
Pressure: PN10 to PN450,150 to 900
Body Material: Cast Iron, Ductile Iron, 316L, SS304, SS316,CF8M, SS316L, SS904L,Wcb, Wcc, wc9, wc6
End: Flanged, Socket weld, Butt weld.
Operation: Electric actuated.
Electric Actuator Details:
The actuators shall be suitable for use on a nominal volt, phase, _Hz power supply and are to incorporate motor, integral reversing starter, local control facilities and terminals for remote control and indication connections housed within a self-contained, sealed enclosure.
As a minimum the actuators should meet the requirements set out in EN15714-2 and ISA SP96.02
In order to maintain the integrity of the enclosure, setting of the torque levels, position limits and configuration of the indication contacts etc. must be carried out without the removal of any actuator covers and without mains power over an Infrared or Bluetooth® wireless interface. Sufficient commissioning tools must be provided with the actuators and must meet the enclosure protection and certification levels of the actuators. Commissioning tools must not form an integral part of the actuator and must be removable for secure storage / authorized release. In addition, provision shall be made for the protection of configured actuator settings by a means independent of access to the commissioning tool. Provision shall be made to disable Bluetooth® communications or only allow a Bluetooth® connection initiated by an Infra-Red command for maximum security.
The actuator shall include a device to ensure that the motor runs with the correct rotation for the required direction of valve travel irrespective of the connection sequence of the power supply.
For more details visit here : https://www.valvesonlyeurope.com/product/electric-actuated-gate-valve-2/
Comments